Ask, and the workshop answers

I’ve been playing around some more with the machine layout, and have come up with something that looks a great deal more workable. The latest layout started by considering the position of the tablesaw, and resulted in it being spun 270 degrees. Yes, I know that makes no sense whatsoever, but I started by rotating it anticlockwise 90 degrees before deciding it would be better facing the other way and up against the pillar rather than the wall.

Things gained momentum from there, as that placed the tablesaw in range of the 15A GPO I had originally planned for it (as a bonus for the location choice). It also allowed sufficient infeed, out feed and side clearance for full sheets to be cut- another indication I was on the right track.

Next, I pushed the bandsaw out of the way, and decided where best to place the router table, up against the wall. That then provided a logical place for the bandsaw, and I noticed I had laid out each of the cutting and shaping machines around a common central area.

20140223-082850.jpg

Not too bad if I do say so. I can see this working rather well.

The question about the location of the dust extractor became glaringly obvious. Looking at the thicknesser, jointer, bandsaw and drum sander, they were all pointing (with their dust chutes) to the same location. Back to my original plan for the dust extractor. No, not the mezzanine- my original plan when first designing the shed. The triangular courtyard between the two wings of the shed. Sure, I need to fill the area in so the extractor is protected from the elements, but it is logical. Furthermore, it puts the extractor within range of the GPO I had installed specifically for it- another bonus.

The two main sawdust generators (jointer & thicknesser) are close to, and have a direct path to the extractor. The next is the Torque Workcentre, and it is just on the other side of the wall, as is the drum sander. The tablesaw is a bit further, but it produces a much finer dust that will carry easily. The only tool left out then is the router table. I will either bring pipe work over the top to it, or consider its location further- it may be possible to get it co located as well.

So when asking where the extractor should go, the shed pointed the way.

20140223-083958.jpg

20140223-083958

2 Responses

  1. Stu personally I would have the saw bench rotated 180 degrees.
    With what you have now you have to bring the sheet goods in and rotate around then push them back out then bring in again. Same with long lengths.
    Better to rip to size the move to the mitre saw and cut to lenght with out coming in and going out then coming back in again. just my 2c worth

  2. Looking good, though, Stu. Soon you’ll actually be able to make something!

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: