Sawdust and Shavings

I did get into the ‘workshop’ as planned, and churned out a couple of ManSpace signs on the CNC machine (one carved, one bas-relief)

_DSC2475

before moving onto what I was actually planning to work on – the start of a rocking horse as recently built by a friend.  He kindly gave me his templates and the plans, so I was able to jump straight into it.

_DSC2478This was about 90 minutes work with a bandsaw and a template copy bit on the router.  Still lots of joining, gluing, shaping and finally finishing to go, but getting to make sawdust and shavings was a palatable relief after so long.

One of the first things I went to do was fire up the generator to try out the 15A tools.  The tablesaw fired up without a problem, but the thicknesser was another story.

It kept tripping the generator out.

Now I am rather confused by this.  The generator is a 6.5KW, so isn’t like it is short of power.  Before the move, the thicknesser was working ok, and I subsequently tried (successfully) to turn it by hand (power disconnected, by pulling on the belts).  So why could the generator not get it up to speed?  It isn’t like the generator wasn’t turning the motor, just extremely slowly under maximum load (with the engine labouring) before the circuit breaker kicked out.

I’m not in a position to be able to test the thicknesser any other way – it is way too heavy to move to somewhere there is 15A available, and I don’t have any currently at the property (at least not accessible (aka oven)). Green steam sucks – anything that needs imaginary numbers to describe how it works is obviously magic. (No, I’m not kidding – you need to understand imaginary numbers to perform some of the multi-dimensional calculations involving frequency and phase-shifts

The voltage in a circuit is 45 + j10 volts and the impedance is 3 + j4 ohms.  What is the current?
Answer:
E = I • Z
45 + j10 = I • (3 + j4)

7 – j6 amps

j represents √-1 (also shown as i in non electrical engineering applications).

See what I mean?! Once upon a time I used to understand this stuff.  Happy to have brain-dumped it after the exams!)

What it all boils down to, is the thicknesser will just have to wait until the new shed, and the subsequent installation of a power supply.  At least the tablesaw is functional again – even if it wasn’t used for the rocking horse (yet).  The steps followed so far were all managed on the bandsaw and router table.

 

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s

%d bloggers like this: